¶ Step 1 - Note:
- Store all components securely, as they will be reused in the next chapter.
¶ Step 2 - Remove the right stepper motor - Part 1
- Remove the M3x40 Countersink screw
- Remove the 3x6x30mm spacer
- Remove the four M6x12 Cap head Screws
- Partially unthread the M5x45 cap head screws, but do not remove them completely; just disengage them from the hidden M5 locking nut
- Remove the top assembly as shown
¶ Step 3 - Remove the right stepper motor - Part 2
- Remove all the M6x12 Cap Head Screws
- Remove the stepper motor assembly from the V-Core 4
¶ Step 4 - Disassemble the remaing parts - Part 1
- Remove the M6x12 Cap Head Screws
- Remove the 3030 M6 T-nuts
- Remove the ball bearing
- Remove the 5x8x4mm spacers
¶ Step 5 - Disassemble the remaing parts - Part 2
- Remove all the bearings from the screws
- Remove the mini precision shim
- Remove the 5x8x14mm spacer
- Remove all the bearings from the screws
¶ Step 6 - Disassemble the remaing parts - Part 3
- Untighten the set screw on the stepper motor pulleys
- Remove the pulleys from the stepper
- Remove the Stepper motor