¶ Step 1 - Assemble X Drag Chain
- X Drag Chain. Will be roughly 200mm longer than your X Axis.
- Cap Head Screw M4x8mm
- Drop-in T-Nut M4. Screw into position, but don't tighten yet.
- Cap Head Screw M4x25mm
- Drag Chain Printed Part
- Hex Locking Nut M4
- Cap Head Screw M5x45mm
¶ Step 2 - Assemble Y Drag Chain
- Y Drag Chain. Will be about 200mm longer than your Y axis.
- Hex Locking Nut M4
- Drop-in T-Nut M5. Screw them into position, but don't tighten yet.
- Drag Chain Printed Part
- Cap Head Screw M4x20mm
- Cap Head Screw M5x45mm
¶ Step 3 - Mount X Drag Chain
- Fit the Drop-in T-Nuts pre-mounted on the drag chain inside the 2020 profile slot and tighten the screws.
¶ Step 4 - Mount Y Drag Chain
- Fit the Drop-in T-Nuts pre-mounted on the drag chain inside the 2020 profile slot and tighten the screws.
- [https://ratrig.dozuki.com/Guide/Wiring+Diagram/38|Wiring Diagram]